SMART LightRaise - Page 43

SMART LightRaise Installation and User's Guide 35
8
Route the cables around or through the middle of the spacer bracket.
NOTE:
After the console is mounted, the cables can be routed into a grommet on either
side or on top of the console.
To attach the wall-bracket covers:
1
With the boom in the raised operating position, tilt the lower cover and maneuver it
between the struts and the boom. Slide it over the lower boom bracket and under the strut
ends. Ensure the cables are inside the cover and aren't pinched or bent.
Lower Boom Cover
2 To install the lower boom cover on a concrete or cinder block wall,
ensure the cables
are hidden behind the cover. Use the supplied masonry drill bit to drill holes at the two
locations in the cover. Insert a concrete screw into each hole and use the Phillips hand
screwdriver to tighten each screw.
To install the lower boom cover on a wall with studs,
mark the two hole locations and
remove the cover. Use the Phillips hand screwdriver to insert a drywall anchor into each
marked location. Follow step 1 to return the lower cover to its place. Ensure the cables are
hidden behind the cover. Insert a #8 x 1¼" truss head screw into each drywall anchor and
use the Phillips hand screwdriver to tighten each screw.
NOTE:
If the hole is at a stud location, insert the truss head screws directly into the stud.
Don't use an anchor.
3
Tilt the upper boom cover and maneuver it between the struts and the boom.
Upper Boom Cover
Groove on
Lower Boom
Cover
Lower Boom Cover
Upper Boom Cover
Groove on
Lower Boom
Cover
Lower Boom Cover