SMART LightRaise - Page 42

34 SMART LightRaise Installation and User's Guide
4
Release the boom, letting it rise to its operating position.
5
Snap on the two plastic lower covers at the locations indicated below.
Telescoping
Beam Lower Cover
Main Beam Lower Cover
NOTE:
You may have to cut the end of the telescoping beam lower cover. Measure the cable
trough and use the plastic cutting tool. Be careful to cut the cover at the correct length.
6
Decide which side of the struts you want the cables to hang on. Feed the cables around
both the strut and the hanger bracket.
7
Loop the cables in large, fairly flat open loops that are located behind the final position of
the SMART Board interactive whiteboard. Ensure the loops are flat enough that they won't
interfere with the interactive whiteboard. Use the provided tie wraps to hold the loops to
the hanger bracket.
Tie Wraps
NOTE:
The
boom should be
slightly above
level when in its
operating
position.