Smarter tools ST-GP6500 - Inspection, Cleaning, and Maintenance; Changing Oil

GP Series
20
©2014 Smarter Tools, Inc. All Rights Reserved
Inspection, Cleaning, and Maintenance
______________________________________________________________________________________________
The owner/operator is responsible for all periodic maintenance.
WARNING!
MAKE SURE THE ENGINE POWER SWITCH IS IN ITS “OFF” POSITION. DISCONNECT THE SPARK
PLUG WIRE AND ALLOW SUFFICIENT TIME FOR THE ENGINE AND GENERATOR TO COMPLETELY
COOL BEFORE PERFORMING ANY INSPECTIONS, MAINTENANCE, OR CLEANING.
•
Before each use, inspect the generator. Check for:
- Loose screws
- Misaligned or binding moving parts
- Cracked or broken parts
- Damaged electrical wiring
- Any other condition that may affect safe operation.
• If an engine problem occurs, have it checked by a qualified service technical before further use. DO NOT use
damaged equipment.
WARNING!
NEVER OPERATE A DAMAGED OR DEFECTIVE GENERATOR.
• Before each use, make sure the engine’s oil level is at manufacturer’s specification. If necessary, fill the
crankcase until the oil level is even with the oil fill hole. Make sure there is gas in the unit.
• Before each use, remove all debris with a soft brush, rag, or vacuum.
• Lubricate all moving parts using a premium quality, lightweight machine oil.
CAUTION:
DO NOT ATTEMPT TO ADJUST, MODIFY, OR DISABLE THE FACTORY INSTALLED GOVERNOR.
TAMPERING WITH THE FACTORY SET GOVERNOR WILL VOID YOUR WARRANTY.
Note: Complete all scheduled maintenance in a timely manner. Routine maintenance will ensure years of
satisfying service out of your product
Changing Oil
Change oil when the engine is warm. Use SAE 10W-30 grade engine oil.
1. Remove the oil drain plug with socket and extension.
(12mm or 17mm dependant on engine size)
2. Allow the oil to drain completely.
3. Replace the drain plug.
4. Remove oil fill cap/dipstick to add oil.
5. Add engine oil and replace oil fill cap/dipstick.
6. Dispose of used oil at an approved waste management facility.