SMARTFOX Pro 2 - Settings: Relay Special Functions - Temp Parameters; Heating Rod 2 Parameters and Changeover Temp

SETTINGS - RELAY SPECIAL FUNCTIONS
www.smartfox.at
R 2 N = 0 0 0 T D = 0 0 M P
= 0 6 0 0 W T H = 0 0 0 M
u m s c h a l t e m
p 6 0 c
ATTENTION!
The connection of a PT1000 temperature sensor is required for the function.
Set the nominal power of the second heating rod under P.
Set the desired changeover temperature.
Complete instructions "2nd heating rod function" at www.smartfox.at/downloads
35