HRX-OM-K003
Chapter 3 Transporting and Installation
HRW Series 3.1 Transporting
Chapter 3 Transporting and Installation
3.1 Transporting
This system is heavy, which poses potential danger at transportation.
When transporting this system, the following safety precautions should be
observed to prevent system damage and breakdown.
Proper procedure must be followed when using this system.
Exercise caution to assure personnel safety during the installation,
operation, maintenance, and inspection of the system.
Only personnel, who have adequate knowledge and experiences with
not only this system but associated equipment are allowed to perform
transport, installation, and maintenance involving potential hazardous
task.
For transporting with the forklift, be sure to insert the fork into a
designated position, referring to “3.1.1 Transporting with forklift” on
page 3-2.
Do not set this system on its side during transportation.
Drain the remaining fluid out of the pipe as much as possible.
The remaining fluid may spill if disregarded.
Exercise caution not to damage the panel and piping with the forklift
when transporting the system.