SMC Networks PTE-300-V

To Next Page

To Previous Page

“The priority of EUROSMC, S.A. is to obtain the highest standards and quality in all

our products, serving to satisfy the expectations and necessities of our clients”.

Main Page

Table of Contents3
Pte-300-V Contents List6
Introduction7
Main Functional Features7
Applications8
Operational Principles10
General10
Front Panel Controls11
Intelligent Generator Module12
Power Supply12
Controls Description13
Main Supply Section13
Main Voltage Supply13
FIXED 110 V C.a. VOLTAGE SUPPLY14
Frequency Section14
Control Keys and Knobs14
Mode Funtion14
Ramp Parameters Selection15
Start the Selected Ramp15
Regulation Digit Selection15
Rotating Control Knob15
Displays and Optic Indicators16
Function MODE Indicators16
Ramp Indicators16
Selection Indicators17
Selection Display17
CONNECTORS: Auxiliary Frequency Output17
Power Outputs18
Level Section19
Control Knobs and Press Keys19
Optical Indicators and Displays21
TAPS: Output Taps23
Phase Section24
Control Knobs and Press Keys24
Optical Indicators and Displays25
General Control Sections26
Control Keys26
Reset26
Print26
RS-232 Serial Port Control26
Synchronization27
MASTER/SLAVE Control27
Optic Indicators27
RS-232 Port Indicator27
SYNCHRONIZING REFERENCE Indicators27
Monitor State Indicator28
Connectors and Fuses28
Monitor Input Taps28
Auxiliary Output to Start an External Timer28
RS-232 Connector29
Functions: Use and Descriptions30
Frequency Section30
Initial Status30
Function Mode Selection30
Normal Frequency Mode (F)30
Slip Frequency Mode (∆F)31
Dynamic Test: Selecting Frequency Ramps31
Dynamic Test: Start the Selected Ramp32
Dynamic Test: Step to32
Nd Value32
Ttl Auxiliary Output: Charasteristics and Applications32
Level Section: Output Power32
Initial Status33
Output Mode Selection (V/I)33
Output Range Selection33
Reference Source Selection33
Output Values Selection34
Output Control: On/Off and Alarms34
Dynamic Tests: Step to 2 Value35
Phase Angle Selection35
Phase Angle Sense35
Dynamic Tests: Step to 2 Value37
Use of External Reference Input37
General Control Section38
Signal Monitor38
Use of the Master/Slave Press Key38
Communication in Bus-Pte39
Events in Bus-Pte39
Event Transmitted by a Pte-300-V40
Special Functions40
Auto off40
Failures Detection41
Specifications43
Frequency Generator43
Power Generators44
External Reference Input45
Signal Monitors45
Available References45
Container45
Technical Assistance, after Sales Service and Warranty46
Warranty46
After Sales Support46
Other Eurosmc Products46

SMC Networks PTE-300-V - Page 2

Table of Contents

Related product manuals