Smeg STA4645 - Troubleshooting Minor Problems

Rev 0.0 35
USER INSTRUCTIONS
EN
Prolonged disuse
Run the soak program twice in succession.
Unplug the power cord from the socket.
Leave the door slightly open in order to prevent the formation of unpleas-
ant odors inside the washing tank.
Fill the rinse-aid dispenser.
Shut off the water supply tap.
Before starting the dishwasher after prolonged disuse
Check that there are no deposits of sludge or rust inside the water pipe: if
there are, allow the water to run from the water supply tap for a few min-
utes.
Plug the power cord back into the socket.
Reconnect the water intake hose and open the tap again .
5.6 Troubleshooting minor problems
In some cases it is possible to remedy minor problems by referring to the fol-
lowing instructions:
If the program fails to start, check that:
the dishwasher is connected to the electrical power supply;
there is no power failure;
the water tap is open;
the dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
the drain hose is not kinked
the drain siphon is not obstructed;
the dishwasher fi lters are not clogged.
If the dishes do not come out clean, check that:
the correct amount of detergent has been added;
there is regenerating salt inside the special container;
the dishes are being loaded correctly;
the selected program is suitable for the dish types and their degree of soil-
ing;
all the fi lters are clean and positioned correctly;
the spray arm nozzles are not obstructed;
there is no object obstructing the rotation of the spray arms.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•