SMH Technologies FlashRunner Cube Series - Programming Commands

3
33
FlashRunner Cube User’s Manual
Programming Commands
Syntax
#load –l <driver> -m <manufacturer> -d <device>
#dev –o begin
#dev –o end
#dev –o set –p <parameter> -v <value>
#conf –o begin
#conf –o end
#conf –o set –p <parameter> -v <value>
#prog –o begin
#prog –o end
#prog –o cmd –c pps -v <pps value>
#prog –o cmd –c connect
#prog –o cmd –c disconnect
#prog –o cmd –c unprotect
#prog –o cmd –c erase –m <mem type> -t <tgt addr> -l <len>
#prog –o cmd –c blankcheck –m <mem type> -t <tgt addr> -l <len>
#prog –o cmd –c program –m <mem type> -s <src addr> -t <tgt addr> -l <len>
#prog –o cmd –c verify –v <ver mode> –m <mem type> -t <tgt addr> -l <len>
#prog –o cmd –c read –m <mem type> -s <dst addr> -t <tgt addr> -l <len>
Parameters
<driver> Filename of the .wnd driver.
<manufacturer> Target device’s silicon manufacturer.
<device> Target device code.
<parameter> Target parameter to set.
<value> Value of the corresponding parameter.
<pps value> on or off.
<mem type> Target memory type.
<tgt addr> Target start address.
<len> Data length.
<src addr> Source (buffer) start address.
<ver mode> Verify mode: read or chks.
<dst addr> Destination start address.
Description
Perform various programming settings and operations on the target device.
http://smh-tech.com.cn sales@smh-tech.com.cn +86-15250087885