Commands
3
34
Status Commands
Syntax
#status –o ping
#status –o get –p err –v <site> –l <errlevel>
Parameters
<site> 1 to 8 to get programming site errors. Use 0 to return system errors.
<errlevel> 1 to 3.
Description
Get instrument status or error information.
When retrieving error information, one or more error lines (depending on
the <errlevel> parameter) are returned. Each line begins with a 32-bit code,
which codifies the following information:
Bit 31: Reserved
Bit 30: If 1, an error message in text format is available.
Bit 29: If 1, the error is programming site specific.
Bit 28: If 1, the error is driver (programming algorithm) specific.
Bit 27: If 1, the error is a system fatal error.
Bits 26 to 24: Reserved.
Bits 23 to 0: Error code. If bit 29 is 1, then bits 7 to 0 signal whether
programming in the corresponding programming site (bit
7 = programming site 8, bit 0 = programming site 1) was
successful (bit = 0) or not (bit = 1).
http://smh-tech.com.cn sales@smh-tech.com.cn +86-15250087885
To Next Page
Loading...