Smiths detection eqo - Switching on the Remote Station

To Next Page

To Previous Page

Start up

Switching on the remote station

 Turn the key switch  of the remote station clockwise (into pos-

ition II) in order to switch on the unit (see Fig. 57). The key

switch will backslide automatically to position I and the green

LED  lights up.

After the initial boot sequence, a splash screen will appear (see

Fig. 61) on the monitor, which will clear after approximately five

minutes when the system has started. During that time the remote

station is performing several start-up activities. The text on the

progress bar reflects the system start-up activities.

One of these start up activities is to search for a local station to

connect to. If the remote station locates the local station it estab-

lishes a connection and a message box is displayed, that a connec-

tion to an eqo local station has been established (see Fig. 59).

 Acknowledge this message by pressing

At the same time a message will appear at local operator station

which informs the local operator that a remote station has made a

connection to the local station.

 Acknowledge this message by pressing

Fig. 57: Key switch of the remote station

Fig. 60: Connection established with remote

station

Fig. 59: Connection established to local station

Fig. 58: Splash screen