Start up
Audio communication
In combination with the eqo system three different audio commu-
nication configurations are possible.
No audio solution provided
Wireless audio base at local station only
Wireless audio base at local and remote station
In the following the different audio communication configurations
will be described in detail:
No audio solution provided
If no audio solution has been provided, it may be the case that you
are already using a communication solution or your concept of op-
eration does not require and a communication solution.
Audio base at the local station only
A wireless audio base is located at the local station of the eqo sys-
tem. This facilitates up to four operators to conference over an au-
dio channel to one another.
To protect the subject's privacy the system is configured with local
and remote stations. The remote stations are physically separated
from the local station. The remote operator subscribes his headset
to the audio base connected to the local station.
Important!
Depending on the proximity of the local and remote sta-
tions and customer requirements a second base may be
mandatory.
Audio base at local and remote station
One wireless audio base is located at the local station, a second
one at the remote station of your eqo system.
Up to four local operators subscribe their headsets to the wireless
audio base connected to the local station, the remote operator sub-
scribes his headset to the base which is connected to the remote
station.
The communication link between local and remote operator station
is established via a network connection between local and remote
station using Voice over IP (VoIP). This communication link is con-
trolled by the eqo system and only established as long as a scan-
ning process is is active.
95591706 11/02/2010 © smiths detection proprietary information
44
To Next Page
Loading...
Need help?
General