Mx37y_Technical_Description_ENG_v2.00.doc
26
─ Single- and three-phase electronic meters with built-in DLC
modem, GSM/GPRS modem or RS485 comm. interface
Fig. 34: Assembly of ZO3 plug-in switching device
Fig. 35: MT372 meter with ZO3
plug-in switching device
5. Additional meter functions
• Collection of energy consumption information in
subsequent billing periods of individual customers
and/or a (larger) number of customers.
• On request, reading of energy consumption
information.
• Collection of supply quality information (e.g. sags,
voltage measurements) of individual customers.
• Collection of information saved in profiles of
individual customers and/or a (larger) number of
customers.
• Collection of power failure duration information of
individual customers and/or a (larger) number of
customers.
• Prepaid functionality.
• Setting and retrieving different tariff structures
(i.e. different combinations of tiers and timeslots)
including the consumption thresholds in the meter
of individual customers and/or a (larger) number
of customers.
• Remote setting of an energy / power
consumption thresholds of individual customers.
• Remote setting of an energy / power
consumption threshold groups of customers (e.g.
“Code Red”), by a broadcast with group identifier.
• Retrieving device status.
• Remote connecting and disconnecting the energy
supply of individual customers.
5.1. On request reading of E-meter
The “On request reading of E-meter” is a service for
meter reading requested by a call centre agent during
a customer call. The meter reading represents the
current reading of the meter display.
5.2. Billing registers reading of E-meter
Meter read in order to prepare energy or other object
instances measurement values. Values are the basis
for preparing an invoice paper. In this case the meter
reading is stored at the end of a billing interval and
captured at a specific defined moment. Meter reading
is time stamped at the end of a billing interval. A
billing interval is configured in advance and can be
changed remotely.
5.3. Scheduled reading of E-meter
The meter reading is scheduled later e.g. at the
moment of a tariff changeover, or at an energy
supplier switch.
5.4. Historic reading of E-meter
Meter reading for analysis, for reference, for disputes
on invoices and to enable recovery of lost data, both
billing and scheduled readings.
5.5. On request reading of G-meter
The “On request reading of G-meter” is a service of
electricity meter. Read is invoked by a call centre
agent during a customer call. The meter read
represents the current reading of the meters. External
meters are connected to the E-meter with the M-Bus.
5.6. Billing registers reading of G-meter
The ”Billing registers reading of G-meter“ is meter
reading in order to prepare a monthly, quarterly or
yearly invoice. In this case, the meter reading is
stored at the end of a billing interval and captured at
a specific defined moment. Gas meter reading is time
stamped at the end of a billing interval. A billing
interval is configured in advance and can be changed
remotely.
5.7. Scheduled reading of G-meter
The gas meter reading is scheduled later e.g. at the
moment of a tariff changeover, or at an energy
supplier switch.
To Next Page
Loading...
