106
Scope Multimeter Operations Operations
Snapshot
The Snapshot tab of the Setup dialog box opens a window that allows you to select how much
data is captured after a triggering event (Figure 9-17).
Figure 9-17 Sample Snapshot dialog box
Selections range from ten to ninety percent in increments of ten, the current setting is highlighted.
Select a button, then select OK to close the dialog box.
Refer to "Trigger Controls‚" on page 101 for information on how to setup a trigger.
Cursor Controls
The cursor controls include a Show Cursors check box plus a slide control and arrows for moving
the cursor position left or right. Select Cursors from the toolbar to open the Cursors dialog box
(Figure 9-18).
1— Cursor 1 controls
2— Cursor 2 controls
3— Hide button
4— OK button
Figure 9-18 Cursor controls
To Next Page
Loading...
