65
Component Test Operations Operations
Figure 7-9 Sample view meter window
Three view meter options are available:
1. With View Meter active (Figure 7-9), tap the toolbar Meter button once and the meter expands
to fill the entire screen.
2. Tap the Meter button a second time and the meter open as a separate window (Figure 7-10).
This window can remain open if you switch to the SCAN MODULE and can be accessed from
the Windows toolbar at the bottom of the screen. You can also resize and reposition the meter
window on the screen.
Figure 7-10 Sample meter view in a separate window
3. Tap the Meter button a third time to close the window and return to the standard view as
shown in Figure 7-9.
4. There are two ways to close meter view and return to the Component Test screen:
– Tap the Close button (red box with an X) on the Scope Viewer toolbar.
– Select More > Exit from the Component Test toolbar.
To Next Page
Loading...
