MASTERYS IP+
40-60 kVA 3/1
ITALIANOENGLISH
32
IOMMASIPXX07-GB 02
8.4 “PARAMETERS” MENU
Displays only the con guration parameters set for the UPS.
The messages in this menu are identi ed by an asterisk in the con gurations service menu.
The parameters can only be changed by entering the service / con gurations menu.
CURRENT DATA menu
Message Description
SINOTTICO Identi e the size, the phases con guation input and output and the serial number
SN. 0000000000 of the UPS.
FW. X.XX CKS. XXXX
LAN SINOTTICO MAC ADDRESS Identi e the mac addres of LAN PCB.
XX . XX . XX . XX . XX . XX
FW X.XX
SCHEDA DIGITALE Identi e the micro prosessor software version.
UP RV 000 CKS: 0000 Identi e the mac addres of LAN PCB.
DSP RV 000 CKS: 0000
8.5 “SERVICE” MENU.
This is used to change the con guration parameters, insert the warranty activation code and display the service
code.
8.5.1 “Activation code” menu.
During activation of the equipment a warranty activation code, made up of four characters, is requested to
complete the start-up procedure.
MANUFACTURER WARRANTY VALI-
DATION
PLEASE INSERT THE CODE
The activation code is provided directly by the reference Support Centre upon communication of the serial
number of the equipment which is displayed in the next message by pressing ENTER.
SEE INSTALLATION MANUAL
FOR PROCEDURE
SN: 0000000000
When contact is made with the Support Centre for the activation code, detailed information can be obtained
on the UPS functions available and on the periodic preventive maintenance programmes.
MENU
8
To Next Page
Loading...
Need help?
General