6
3 Running a Measurement
There are two measurement modes available on the Piccolo-II: “Single-Store” and “Auto-Store”.
The Single-Store runs a single average period and stopes after the specified duration or when the
user stops the measurement.
The Auto-Store runs a series of average periods one after the other until the user stops the
measurement or until the memory is full.
3.1 Single-Store
To start a Single-Store measurement, perform a short-press on the center button.
This will display “run SGLE” on the display for 1s and start the measurement.
Once the measurement is started, the display automatically shows the Leq.
While the measurement is running, the “Avg” indicator will blink and the left-most
segments will rotate indicating a measurement in progress.
To stop the measurement, press the center button or simply wait for the
measurement duration to be elapsed.
When the measurement is over, the record number will be displayed for 1s and the
display will return to the Leq.
Short-Press
Press
To Next Page
Loading...