Software Bisque Paramount MX - Page 83

Paramount MX User Guide
83 | Page
Axis Parameters Description
User Space Version
Shows the current version for the format of the user-defined data that is
saved to the control system’s flash memory.
Focus Axis
MKS 3200. MKS 4000, MKS 5000 and later should be set to 1. Otherwise,
set this value to 0.
Mount Identifier One of the following:
• Paramount ME
• Paramount MX
• Bisque TCS
Debug Output? Set this value to 1 to show control system diagnostics.
Startup Test Joystick RA
If set to 1, then Bisque TCS will abort startup and emit a single beep if the
joystick is not centered when power is turned on.
Startup Test Joystick Dec
If set to 1, then Bisque TCS will abort startup and the control system’s
speaker will emit a single beep if the joystick is not centered when power
is turned on.
Startup Test Joystick
Button
If set to 1, then Bisque TCS will abort startup and the control system’s
speaker will emit a single beep if the joystick button is pressed when
power is turned on.
Startup Test Guider
If set to 1, then Bisque TCS will abort startup and the control system’s
speaker will emit a single beep if any of the guider lines are high when
power is turned on.
Play Guider Sound
If set to 1, the Bisque TCS speaker will emit a single “click” each time the
guider state changes.
IR Enabled
If set to 1, then the infrared communications port is enabled (MKS 4000
only).
Hand controller rate 1 Hand controller rate number 1.
Hand controller rate 2 Hand controller rate number 2.
Hand controller rate 3 Hand controller rate number 3.
Hand controller rate 4 Hand controller rate number 4.
General Purpose I/O 1 General purpose output direction 1.