sol-ark 8K - Page 36

August 3, 2019 36
F25
DC_Feedback_Fault
Contact Sol-Ark.com
F26
BusUnbalance_Fault
Too much load one leg (L1 or L2) Vs the other leg
F27
DC_Insulation_ISO_Fault
Contact Sol-Ark.com
F28
DCIOver_M1_Fault
Contact Sol-Ark.com
F29
AC_AirSwitch_Fault
Contact Sol-Ark.com
F30
AC_MainContactor_Fault
Contact Sol-Ark.com
F31
AC_SlaveContactor_Fault
Contact Sol-Ark.com
F32
DCIOver_M2_Fault
Contact Sol-Ark.com
F33
AC_OverCurr_Fault
Usually caused by Loads that are too large
F34
AC_Overload_Fault
Usually caused by Loads that are too large
F35
AC_NoUtility_Fault
Contact Sol-Ark.com
F36
AC_GridPhaseSeque_Fault
Contact Sol-Ark.com
F37
AC_Volt_Unbalance_Fault
Contact Sol-Ark.com
F38
AC_Curr_Unbalance_Fault
Contact Sol-Ark.com
F39
INT_AC_OverCurr_Fault
Contact Sol-Ark.com
F40
INT_DC_OverCurr_Fault
Contact Sol-Ark.com
F41
AC_WU_OverVolt_Fault
Contact Sol-Ark.com
F42
AC_WU_UnderVolt_Fault
Contact Sol-Ark.com
F43
AC_VW_OverVolt_Fault
Contact Sol-Ark.com
F44
AC_VW_UnderVolt_Fault
Contact Sol-Ark.com
F45
AC_UV_OverVolt_Fault
Contact Sol-Ark.com
F46
AC_UV_UnderVolt_Fault
No Battery and PV Disconnect is Turned OFF
F47
AC_OverFreq_Fault
Contact Sol-Ark.com
F48
AC_UnderFreq_Fault
Contact Sol-Ark.com
F49
AC_U_GridCurr_DcHigh_Fault
Contact Sol-Ark.com
F50
AC_V_GridCurr_DcHigh_Fault
Contact Sol-Ark.com
F51
AC_W_GridCurr_DcHigh_Fault
Contact Sol-Ark.com
F52
AC_A_InductCurr_DcHigh_Fault
Contact Sol-Ark.com
F53
AC_B_InductCurr_DcHigh_Fault
Contact Sol-Ark.com
F54
AC_C_InductCurr_DcHigh_Fault
Contact Sol-Ark.com
F55
DC_VoltHigh_Fault
Check battery voltage, should not be above 59V
F56
DC_VoltLow_Fault
Batteries are overly discharged
F57
AC_BackFeed_Fault
Contact Sol-Ark.com
F58
AC_U_GridCurr_High_Fault
Contact Sol-Ark.com
F59
AC_V_GridCurr_High_Fault
Contact Sol-Ark.com
F60
AC_W_GridCurr_High_Fault
Contact Sol-Ark.com
F61
AC_A_InductCurr_High_Fault
Contact Sol-Ark.com
F62
AC_B_InductCurr_High_Fault
Contact Sol-Ark.com
F63
ARC_Fault
Can be a false alarm or bad PV connection
F64
Heatsink_HighTemp_Fault
Check the built-in fans, ambient temp may be to high