Sol Welding INOXA SERIES User Manual

This manual must be completed by the “CE Operating and service maual”
This manual must be completed by the “CE Operating and service maual”
Diese Betriebsanleitung muß durch die ”CE Betriebs- und W
Diese Betriebsanleitung muß durch die ”CE Betriebs- und W
artungsanleitung” ergänzt werden.
artungsanleitung” ergänzt werden.
Ce livret doit etre integré avec "Livret 'usage et manutention CE"
Ce livret doit etre integré avec "Livret 'usage et manutention CE"
Questo manuale deve essere integrato dal ”Manuale d’uso e manutenzione CE”
Questo manuale deve essere integrato dal ”Manuale d’uso e manutenzione CE”
El presente manual debe ser adjuntado al “Manual de uso y manutención CE”
El presente manual debe ser adjuntado al “Manual de uso y manutención CE”
Printed in date 02/10/08
Printed in date 02/10/08
Rev
Rev
. 00
. 00
INOXA 250 HF
INOXA 360 HF
INOXA 250 HFP
INOXA 360 HFP
INOXA SERIES
Sol Welding
Manuale Istruzioni
Instruction Manual
Livret d'Instructions
Betriebsanleitung
Manual de instrucciones

Sol Welding INOXA SERIES Specifications

General

Welding Type	MIG/MAG
Frequency	50/60 Hz
Power Factor	0.93
Welding Current Range	30-250A
Insulation Class	H
Efficiency	85%
Wire Diameter	0.6-1.0mm

Summary

2. General Precautions

3. Electrical Emergency Normatives

4. Antifire Emergency Normatives

5. Main Line Connections

6. Commands Description

Front Panel Controls Overview (Fig. 1)

Overview of main controls and indicators shown in Fig. 1.

Function and Parameter Selection Controls

Remote Control and Torch Connections

7. Electrode Installation

7.1 Electrode Holder Connection

Procedure for connecting the electrode holder to the machine sockets.

7.2 Connection to Base Material

Procedure for connecting the ground cable to the workpiece.

7.3 Electrode Mode Selection

Steps to select the welding mode for electrode welding.

7.4 Remote Control Regulation

7.5 VRD Function Activation

8. TIG Installation

8.1 TIG Torch Connection

Procedure for connecting the TIG torch and gas supply.

8.2 Connection to Base Material

Procedure for connecting the ground cable for TIG welding.

8.4 Cooler Unit Connection (Optional)

8.6 TIG Mode Selection

Procedure to select TIG welding modes (2 Times/4 Times).

8.7 TIG HF / LIFTARC Ignition

Methods for initiating the TIG arc using HF or Liftarc.

8.8 TIG DC Operating

Detailed operation procedures for TIG DC welding.

2 Times Cycle Operation

4 Times Cycle (2nd Level) Operation

8.9 UP SLOPE AND DOWN SLOPE REGULATION

8.11 SECONDARY PARAMETERS REGULATIONS (Only on INOXA HFP series)

8.12 PULSATION (Only on INOXA HFP series)

8.15 REMOTE CONTROL REGULATION

Remote Control Connection Options

9. WARNING SIGNALS

Overheating Protection

Description of the overheating protection and its indicator.

Lack of Water Protection Device (Optional)

Explanation of the water cooler protection and its indicator.

10. TECHNICAL SPECIFICATIONS

Power Source Specifications