Chapter 3: Installing the Inverter
Install the inverter either before or after the modules and power optimizers have been
installed.
NOTE
Use only copper conductors rated for a minimum of 75°C/ 167°F.
Inverter Package Contents
One inverter with Safety Switch (if applicable)
Mounting bracket kit
Safety Switch sealing cover (if applicable, for use in case of inverter replacement)
Quick Installation guide
Identifying the Inverter
Refer to the sticker on the inverter that specifies its Serial Number and its Electrical
Ratings. Provide the serial number when contacting SolarEdge support. The serial
number is also required when opening a new site in the monitoring platform.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.3
26 Chapter 3: Installing the Inverter
To Next Page
Loading...
