The system starts automatic detection of the follower inverters connected to the
leader inverter. The inverter should report the correct number of followers. If it does
not, verify the connections and terminations.
6. To check the follower IDs and last communication time, select RS485 è Follower
List.
7. Verify the connection of the leader to the monitoring platform, as described in the
next section.
Verifying the Connection
After connecting and configuring a communication option, perform the following
steps to check that the connection to the monitoring server has been successfully
established.
1.
Go to Commissioning >Status.
2. In the Summary section, under Server Comm., make sure S_OK is displayed
together with the selected communication option.
3.
Scroll down to the Communication section and check that the communication
options are as required.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.3
60 Verifying the Connection
To Next Page
Loading...
