d-1-6) P(u) Function( applies to NZS4777.2)
P(U) function is Volt-watt response mode which is required by standard NZS4777.2
.and applies to NZS4777.2 only.
The default value is “enable”. Choose “disable” means the funciton is turn off.
Mode Select
>Enable<
P(U) Funciton
d-1-7) DRM Function( applies to NZS4777.2)
DRM function is Demand Response Mode which is required by standard NZS4777.2
.and applies to NZS4777..2 only.
The default value is “enable”. Choose “disable” means the funciton is turn off.
Mode Select
>Enable<
DRM Funciton
d-1-8)Self Test (applies to CEI 0-21 only)
user can test operating status of inverter by choosing ”Start Test” . It will turn back
to the Home page automatically and shows ”SelfTesting...”. 60 seconds later, it will
display “success” , which means selftest completed successfully. Then it will turn
back to the“Test Report” page as below automatically and shows specic parameters.
Start Test
Test Report
Test Report
OvpValue 0.0V
OvpTime 0ms
01234560123456
Setting Setting
54
55
>Func Select
>Enable<
Remote Control
connecting...
d-1-5) Remote Control
Remote control function allows external control device to make the inverters
remote cluster control through LAN port on the inverter. And it can control the
inverter’s active power output and reactive power output.
The default value is “enable”. Choose “disable” means the funciton is turn off.
To Next Page
Loading...
Need help?
General
