Power Limits
0.00
6.
> Proportion
User can set the power limit here,
the setting value is between 0.00
and 1.1.
72
73
> O/V Stage1
0.0
5) Grid Protection
Usually end user do not need to set the grid Protection. All default values
have been set before leaving factory according to safety rules.
If reset is needed, any changes should be made according to the
requirements of local grid.
6) New Password
The user can set the new password here. We need to increase or
decrease the word by pressing “Up” or “Down” button. Long press “Down”
to confirm and alternate to next word. After word is confirmed, long press
“Down” to reset the password.
New Password
0 0 0 0
RS485 CommAddr
Set Address
2
Parallel Switch
Enable
ParallelSetting
>
7) RS485 CommAddr
If “Enable” is selected, the inverter will communicate with the computer,
through which the operating status of the inverter can be monitored. When
multiple inverters are monitored by one computer, RS485 communication
addresses of different inverters need to be set. RS485 function will only be
effective when the address is identical. The default address is “1”.
8) ParallelSetting
When the user wants to use the parallel system with Modbus Function,
enable this function and complete the settings following the instructions in
section “Parallel Connection”. If not needed, disable this function.
There are 4 modes for selection: “Off”, “LowFreqScan”, “MidFreqScan”,
“HighFreqScan”. It shows the frequency of PV panel scan.
If “LowFreqScan” is selected, the inverter will scan the PV panel by low
frequency.
Time for LowFreqScan: 4h; for MidFreqScan: 3h; for HighFreqScan: 1h..
To Next Page
Loading...
