Solax X1 Series - System Reset and Control Functions; Reset Functions and Machine Type; Adapter Box, Earth Detect, and Dry Contact

74 75
The user can clear the meter and CT energy by this function. Press “Up”
or “Down” button to select and long press “Down” to confirm. (The user
can select “Yes” to reset meter if the user uses meters)
The user can clear the power energy of CT and meter by this function (if
the user uses meters)
14) Machine Type
The user can check the Machine Type by this function.
X1-MINI-3.3K-G4
>Machine Type
15) vChargerEnableE
The user can turn on EvCharger function by select "Enable".
Mode Select
> Enable/Disable <
EvChargerEnable
Machine Type
There are three functions(Disable/Manual/Smart Save) which can be selected for
Load Management. “Disable” means the heat pump is off. When “Manual” is
selected the user can control the external relay to remain close or open manually.
“Smart Save” mode can set the values of the heat pump’s on/off time and
conditions, operating modes.
If the user uses the inverter dry contacts to control heat pump through Adapter
box, please refer to the Adapter Box Quick Installation Guide to set the
parameters here.
17) Earth Detect
The user can enable or disable the Earth Detect by this function.
Mode Select
> Enable/Disable<
Earth Detect
18) Dry Contact
The user can use the Dry Contact to connect heat pump by this function
(require SG Ready).
15) Adapter Box G2
The user can connect the adapter box by this function
Mode Select
> Enable/Disable <
Adapter Box
>Load Management<
Dry Contact
Load Management
Disable/Manual/Smart Save
Enter
Back
Mode Select
Load Management