82
Operator Manual
PROBLEM POSSIBLE CAUSE
REMEDY
ENGINE
HYDRAULIC
More
Fuel
Consumption
Air cleaner is dirty / choked
Overloading of engine
Improper valve clearance
Implement setting improper
Less engine temp
Fuel injection nozzle faulty
Clean air cleaner
Reduce load or shift to low gear
Check and adjust
Adjust it and take instrument from dealer for right option.
Check cooling system
Check and service through dealer
Improper inflation pressure
Oil level is high or less
Hydraulic filter element choked
Mechanical linkage may faulty
Bush tight
Response valve setting improper
Improper lift arm setting
Improper internal adjustment
Linkage connection not joint properly
Heavy load on linkage
Draft / position control setting wrong
Implement not working well
Response valve setting very low
Oil level low
Hydraulic filter choked
Hydraulic system faulty
Hydraulic pump not working
Draft / position control setting wrong
Excessive Heating
Of Oil
Linkage Goes
Down Slowly
Linkage Not Lift
Fully
Three Point Linkage
Not Respond To
Lifting While
Operating Hydraulic
Lever
Draft Control Fast
Hydraulic
System Not
Working
Properly
Draft Control Fast
Check and adjust according to specified
Check and maintain proper level
Replace
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Contact your authorized dealer
Make correct adjustment of implement.
Check valve by your dealer.
Check and top up
Replace filters
Check through authorized dealer
Contact your authorized dealer
Contact your authorized dealer and check system
BRAKES
Brakes Noisy
While Applying
Brakes Tractor
Goes In One Side
Wrong adjustment of brakes
Both brakes are not set properly
Check
Adjust
To Next Page
Loading...
