7
2. Safety
2.3 Notice For Use
The Export Power Manager has been constructed according to the applicable safety
and technical guidelines.
Use the Export Device in installations that meet the following specification ONLY:
1. Permanent installation is required
2. The electrical installation must all the applicable regulations and standards.
3. The Export Power Manager must be installed according to the instructions stated in
this manual.
4. The Export Power Manager must be installed according to correct technical
specification.
5. To install the Export Device you should notice the phase of sampling voltage and the
direction of sampling current, then you can connect sampling wires and CT
(current transformer).
To Next Page
Loading...
Need help?
General
