15
V INSTALLATION
To install the appliance:
1. Place the appliance on a stable, at, and heat and moisture resistant surface.
2. Place the bean container 1 on the appliance. Rotate until the bean container locks
in place.
3. Plug the power cable e into a power outlet.
4. Press the power button w to switch on the appliance.
The appliance is ready for use when the cup extraction buttons j k continuously light
up white.
V BEFORE FIRST USE (WATER FILTER CARTRIDGE)
Before rst use, clean the appliance as described in section Daily maintenance.
4
If you don’t want to use a water lter, you can leave the appliance on default settings.
You can skip the following steps in this section.
To place and congure the water lter:
1. Hold the test strip t briey in a glass of tap water.
2. Read the measured water quality on the test strip t.
3. Rotate the selector at the bottom of the water lter cartridge 9 to the optimal
position.
Position A For use with soft water.
Position B For use with medium hard water.
Position C For use with hard water.
4. Hold the water lter cartridge 9 in a container with water.
5. Gently squeeze the water lter cartridge 9 to remove air bubbles from the lter.
6. Insert the water lter cartridge 9 into the bracket in the water tank 8 with the
selector facing downwards.
7. Fill the water tank 8 with water up to the MAX marking.
8. Press the programming button d to enter the settings menu.
9. Press the steaming function button l to enter the lter settings.
10. Press the single cup extraction button j to set the lter setting to YES.
11. Place a container (min. 0.14 gal) underneath the brewing head 4.
12. Press the programming button d to exit the settings menu. The rinsing process
starts automatically.
To Next Page
Loading...
Need help?
General
