SOLIS GRIND & INFUSE PERFETTA - Page 27

27
11. Open the hopper gate at the back of the bean container 1.
12. Place a container under the portalter holder 3.
13. Switch on the appliance.
14. Press and hold the grind time knob c to switch on the grinder.
15. When all GRINDZ
TM
has run through the appliance, release the grind time knob c
to switch o the grinder.
16. Close the hopper gate.
17. Switch o the appliance and remove the bean container 1 (see image E).
18. Empty the bean container 1.
19. Rinse the bean container 1 with warm water and a mild detergent.
20. Rinse the bean container 1 with clean water.
21. Dry the bean container 1 thoroughly.
22. Reassemble the grinder and the bean container 1. Make sure all parts lock in
place.
23. Fill the bean container 1 with coee beans.
24. Open the hopper gate at the back of the bean container 1.
25. Switch on the appliance.
26. Press and hold the grind time knob c to switch on the grinder.
27. After 20 seconds, release the grind time knob c to switch o the grinder.
28. Set the grind size selector g back to the desired position.
29. Switch o and unplug the appliance.
4
Make sure the portalter is not hot when removing the spout.
30. Unscrew the spout of the portalter s.
31. Soak the following parts in warm water and a mild detergent:
• Portalter s (only the metal parts)´
• Cup lters p a
• Spout
32. Unscrew the steaming nozzle from the steaming wand 5.
4
If the nozzle opening is blocked, you can use the pin on the cleaning tablet holder
to remove the blockage. If you cannot unblock the nozzle with the pin, rinse the
nozzle with warm water and try again.
33. Rinse the nozzle in warm water.
34. Gently screw the nozzle back onto the steaming wand 5.
35. Clean the appliance and the water tank 8 with a soft and damp cloth.
36. Dry the appliance and the water tank 8.
37. Plug in and switch on the appliance.