SOLIS MASTER TOP
Operating Instructions
d) By pressing the programming key ,
the new value is programmed.
The new stand-by time is now pro-
grammed until you change it by re-pro-
gramming the unit.
Note: For safety and energy-saving rea-
sons we recommend that, after switching
to standby (final rinse is made), the appli-
ance be switched off at the main switch
over-night and during absences. For
short absences, the appliance can be
switched to the stand-by mode with the
operating key . For appliances con-
nected to the water supply, the water tap
must be closed.
9.4 Status indicator
a) By pressing the programming key
in stand-by mode, the following
pre-set functions will be displayed:
– if the product indicators are lit =
the pre-brew function is operational,
– if the indicator cleaning/rinsing is lit =
rinsing function is operational,
– the programming display indicates the
time after which the appliance will
automatically switch to the stand-by
mode.
9.5 Standard programming by the
manufacturer
The appliance is programmed by the facto-
ry such that, under normal circumstances,
perfect results are achieved. If you have
changed the pre-set values with your indi-
vidual programming, you can revert to the
standard pre-set values if required.
a) Switch off the appliance at the main
O-I switch (11) and switch it on again.
The appliance is now in the stand-by
mode.
b) Keep the programming key (7) and
the selector key espresso (2)
depressed and simultaneously switch
on the appliance with the operating
key (1). All the factory pre-set stan-
dard values are now set again.
10.0 Grinder adjustment
The grinder is pre-set by the factory in
such a way that perfect results are
achieved with most coffee beans.
However, you have the possibility to
individually adjust the grinder.
81
To Next Page
Loading...
Need help?
General
