SOLIS MASTER TOP
Operating Instructions
Note: If the brewing unit cannot be
properly reinserted, it has probably been
unintentionally moved during cleaning.
In this case, please adjust with the built-
in lever.
13.0 Decalcifying (control indicator
flashes).
At the latest after 1325 operations the
indicator will flash and indicates that
decalcifying is required. Even though you
may continue to make coffee, it is rec-
ommended to decalcify the unit as soon
as possible.
Note: It is always necessary to decalcify
the unit even when using a water filter.
If the water you are using is particularly
hard, you may decalcify the appliance
earlier. It would be an advantage to use
the SOLIS AQUA-SELECT water filter.
The SOLIS MASTER TOP is equipped
with an automatic decalcifying program,
which simplifies the process consider-
ably. The decalcifying program takes
approx. 45 minutes.
Please proceed as follows:
1. Switch off the appliance at the main
O–I switch (11) and switch it on
again. The appliance is now in the
stand-by mode.
2. Remove the container for waste
coffee.
3. Pour the decalcifying agent
SOLIPOL in a 1:1 mixture (1 liter
Solipol and 1 liter water) into the
water container.
4. Put a large container under the steam
nozzle and open/turn the knob
forward to the steam symbol !
Let the residual steam escape.
The knob must remain in the steam
position during the whole decal-
cifying process!
86
To Next Page
Loading...
Need help?
General
