SOLIS MASTER TOP
Operating Instructions
mind.
5sec.
5. Press the decalcifying selector key
(6) for at least 5 seconds until the
decalcifying process starts. The
decalcifying program will run automat-
ically. Please do not interrupt the
decalcifying program! During the
decalcifying program the indicator
will be lit.
6. When the insufficient water and
decalcifying indicators
flash, thoroughly rinse the water
tank, refill with fresh water and
replace.
7. Now press the decalcifying key
again. The entire system will be rinsed
with clean water until the decalcifying
indicator is extinguished.
8. After completion, close the hot
water/steam knob and replace the
waste coffee container.
The unit is now decalcified and after
putting into service is ready for making
coffee.
Important: Regular decalcification of
your appliance avoids expensive repairs.
Any damage caused by an omission to
decalcify, incorrect handling and failure
to follow the instructions contained in
this User’s Manual will not be covered by
the warranty. In particular, do not use
vinegar to decalcify the appliance under
any circumstances. This would severely
damage the appliance.
14.0 Trouble-shooting and possible causes
Before returning the appliance for repair, please read the following
points carefully. This will often solve the problem and save you a lot
of difficulties.
1. Operating switch does not switch on the appliance
– The main switch O – I on the side is not switched on.
– The appliance is not properly connected. Check the fuse.
2. Control indicator flashes
– Brewing unit is not properly inserted or the door is not properly
closed. Check!
If the control indicator flashes together with a number on the
control display:
– This indicates a problem which can only be solved by the
SOLIS after-sales-service or an authorized technician.
3. Control indicators are lit/flashing
– Please see the explanations on control indicators
4. Pump creates loud noises and/or the control indicator is lit
– Water tank is not properly installed. There is air in the system.
Properly install the water tank and vent the appliance by turn-
ing the hot water/steam knob to the position hot water until a
regular jet of hot water emerges. Close the knob and the con-
trol indicator will be extinguished if a selector key is pressed.
87
To Next Page
Loading...
Need help?
General
