Need help?Do you have a question about the Solmeta GMAX and is the answer not in the manual?
General| Category | GPS |
|---|---|
| Update Rate | 1 Hz |
| Compatibility | Nikon DSLR cameras |
| Hot Shoe | Yes |
| Acquisition Time | Cold start: ~35s, Warm start: ~33s, Hot start: ~1s |
| Operating Temperature | -10°C to 60°C |
| Storage Temperature | -20°C to 70°C |
| Model | Solmeta GMAX |
How to add location and direction data to images.
Use the receiver as a tracing logger for route information.
Utilize the receiver as an accurate clock synchronized by GPS/BDS.
Use the receiver as an external timer release device.
Use the receiver with a mobile app for remote camera control.
Steps to power the receiver on and off.
How to obtain GPS/BDS signal acquisition.
Configure the receiver to power on/off with the camera.
Overview of available custom settings and their purpose.
Calibrate the receiver's level or tilt sensors.
Choose between miles, kilometers, or knots for speed display.
Set altitude units and select data source (GPS or barometric).
Select GPS, Beidou, or both for positioning.
Choose how latitude and longitude are displayed.
Configure receiver behavior when GPS signal is lost.
Adjust LCD backlight settings (on, off, delay).
Control GPS/BDS indicators, logging, and button beep.
Turn the digital compass feature on or off.
Calibrate the digital compass for accurate direction readings.
Step-by-step guide for compass calibration.
Select direction based on true north or magnetic north.
Perform level calibration on a horizontal surface.
Steps to select speed units (miles, km, knots).
Steps to choose altitude units and data source.
Set the LCD to show UTC or local time.
Choose the preferred format for displaying dates.
Select temperature display between Fahrenheit and Centigrade.
Choose display units for air pressure (PSI, hPa, bar).
Configure GPS/BDS frequency and working time in Auto mode.
Configure GPS/BDS frequency and working time in Clock mode.
Define the interval for recording travel route data.
Enable or disable the Bluetooth connection.
Reset the receiver to its default factory configuration.
Use the device for timed camera shutter releases.
Operate the camera remotely via Bluetooth and a mobile app.
Utilize the receiver as a highly accurate timekeeping device.
Details of the product's limited warranty.
Important safety and handling guidelines for the device.
To Next Page
