SOLTEK SL-52D2 - Load Setup Defaults

34
Reset
Configuration Data
Choose Enabled or Disabled
(default). Disabled means to retain
PnP configuration data in BIOS and
Enabled means to reset PnP
configuration data in BIOS.
IRQ-x assigned to
DMA-x assigned to
Legacy ISA: Manually assigns
IRQ/DMA to device.
PCI/ISA PnP: BIOS assigns
IRQ/DMA to device automatically.
PCI IRQ Actived
By
Choose Edge or Level (default).
Most PCI trigger signals are Level.
PCI IDE IRQ Map
To
Select PCI-AUTO (default), ISA, or
assign a PCI SLOT number
(depending on which slot the PCI
IDE is inserted). If PCI-AUTO does
not work, then assign an individual
PCI SLOT number.
Primary/ IDE INT# Choose A (default), B, C, or D.
Secondary IDE
INT#
Choose A, B (default), C, or D.
3. Press <ESC> and follow the screen instructions to save or
disregard your settings.
Load Setup Defaults
Load Setup Defaults option loads the default system values
to the system configuration fields. If the CMOS is corrupted
the defaults are loaded automatically. Choose this option
and the following message appears:
“Load Setup Defaults (Y/N)? N”
To use the Setup defaults, change the prompt to ÒYÓ and
press <Enter>.