Chapter 4 BIOS Setup
71
Primary
Master / Slave UDMA
Secondary
Master / Slave UDMA
Ultra DMA33/66/100 implementation is possible only
if your IDE hard drive supports it, if the operating
environment includes a DMA drive, and if your sys-
tem software supports Ultra DMA33/66/100. Select
“Auto” to enable BIOS support.
The choices: Auto; Disabled.
Primary
Master / Slave PIO
Secondary
Master / Slave PIO
Choose Auto or Mode 0~4. The BIOS will detect the
HDD mode type automatically when you choose
Auto. You need to set to a lower mode than Auto
when your hard disk becomes unstable.
The choices: Auto; Mode 0; Mode 1; Mode 2; Mode
3; Mode 4.
USB Controller Select Enabled if your system contains a Universal
Serial Bus (USB) controller and you have USB
peripherals.
USB Mouse Support Select Enabled if your system contains a Universal
Serial Bus (USB) controller and you have a USB
mouse.
USB Keyboard Sup-
port
Select Enabled if your system contains a Universal
Serial Bus (USB) controller and you have a USB
keyboard.
On-Chip Primary/
Secondary PCI IDE
The chipset contains a PCI IDE interface with support
from two IDE channels. Select Enabled to activate
the first and/or the second IDE interface. Select
Disabled to deactivate an interface if you install
a primary and/or second add-on IDE interface.
The choices: Enabled; Disabled.
Init Display First Initialize the chosen video display before initializing
any other display device on the system. Thus the
chosen display becomes the primary display.
To Next Page
Loading...
