in position and tightened with a torque of 23 Nm. Before pushing the die on the guide shaft
(pos. 12), check the guide bushes for free movement and, if required, regrind them. Grease
the die guide and the guide bushes lightly with copper paste. Thereafter, push the die onto the
guide shaft. After pushing the die, fit the cutting punch (pos. 9) in the guide plate by moving
the cropping cylinder many times carefully without damaging the guide. Finally, screw on the
counter bearing (pos. 11) with the spring (pos. 6) and fit the screws (pos. 13) evenly on the
punch and tighten them with a torque of 23 Nm.
To Next Page
Loading...