Step 8 / 14
CASSETTE ROLLER BLIND INSTALLATION
Marking and tting the top & face x brackets
SPACING - Mark 2 x brackets approx 75mm in from
each end, with any additional brackets spaced evenly
between them.
TOP FIX - Position each bracket from the centre of the
xing hole a minimum distance of 45mm from the
back of any obstruction and with the lip to the back.
Mark the position of the holes, then secure in place.
FACE FIX - Position the back of your bracket against
the wall to the height of the blind drop, then mark the
position of the holes and secure the brackets in place.
Step 9 / 14
CASSETTE ROLLER BLIND INSTALLATION
Fitting the cassette
Once all the brackets are in place offer the blind to the
brackets. With the cassette tilted away from you
locate the front lip into the bracket and push upwards
to click the cassette into the back lip of the bracket.
Step 10 / 14
CASSETTE ROLLER BLIND INSTALLATION
Mounting the roller assembly
Hold the roller assembly to the brackets within the
cassette prole with the fabric in the correct position
based on your order (front or rear roll) – the motor
program/reset button should be accessible from
Version 41
7
To Next Page
Loading...
