below.
1. Secure the idle end (opposite the motor end) into
position by locating the ‘+’ shaped plunger into the ‘+’
shaped part of the bracket. When correctly aligned,
the plunger should pop into the bracket and secure in
place.
2. Now angle the motor head side into position and
slot the prongs of the motor head plate into the
bracket, ensuring that the central prong drops into
position on the bracket.
Warning
Important note: Ensure that the plunger
at the idle end (opposite the motor
end) is depressed by at least 5mm
when marking the hole positions.
Tip
Make sure the 'Somfy' logo on the motor
plate is orientated 'UP' for easy coupling
with the bracket.
Version 41
8
To Next Page
Loading...
