Step 11 / 14
POWER UP & TESTING
Your roller blind is tested to ensure it is operating
correctly prior to dispatch. During this process, the
upper and lower stop positions are preset based on
your height measurement. We also pair the control
ordered to the motor (if a control was ordered).
Wake up the motor
To preserve battery charge, the motor is supplied in
‘Sleep Mode’ and requires waking up once the blind is
tted and ready to operate.
To wake up the motor, briey press the program/reset
button on motor head - the blind will jog briey Up/
Down and is ready to operate.
Step 12 / 14
BLINDS SUPPLIED WITH A CONTROL
If you ordered a Somfy control with your blind(s), then
the control supplied will be paired to the motor. Once
you have woken the motor up, test your blind by
pressing the down button on your control.
The blind will travel down and stop at the factory
preset position (this can be adjusted).
Use the directional buttons to test operation.
Tip
Refer to the ‘Adjusting the stop positions’
section to ne tune the stop positions to
your desired position.
Version 41
9
To Next Page
Loading...
