3-2
4. Bow line This line shows the direction in which the ship is going (light blue).
5. External synchronization
The external synchronization mode is activated by menu
selection in the order of "MENU”–“TX”–“TX SYNCRO”–
“EXTERNAL." The mode is indicated as “EXT” on the screen.
6. Internal Memory Number
This field shows the memory number with which the settings
being currently used are stored. The standard value is
indicated as “STD” in red.
7. Gain This field shows the gain of the sonar image that is currently
in use.
8. Tilt This field shows the tilt of the directional
transmission/reception beam that is currently in use.
9. Range This field shows the range of the sonar image that is currently
in use. The range is interlocked with an off-center value.
10. Transmission indication
The mark is displayed during transmission.
11. Hoisting amount The projection amount of the hoisting device is indicated.
12. Date/time The current date and time is shown.
13. Latitude/longitude The latitude and longitude of the user’s ship is shown. If
latitude/longitude information is not input from external
equipment, it will not be displayed.*
14. Ship speed The user’s ship speed information is shown. If the speed
information of the user’s ship is not input from external
equipment, it will not be displayed.*
To Next Page
Loading...