Calibrating the
Appropriate Settings
Automatically
[Auto Calibration]
D.C.A.C. (Digital Cinema Auto Calibration) can
set the appropriate sunound sound
automatically.
• The system outputs a loud test sound when [Auto
Calibration] starts. You cannot turn the volume
down. Give consideration to children and neighbors.
1 Press HOME.
The home menu appears on the TV screen.
Press <--/->to select _ [Setup].
2
3
4
5
Press ,I,14,to select [Audio Settings],
then press @.
Press '1"14,to select [Auto Calibration],
then press @.
The confirmation display for [Auto
Calibration] appears.
Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic fit ear level using
a tripod, etc. (not supplied). The flont of
each speaker should face the calibration
mic, find there should be no obstruction
between the speakers find the calibration
mic.
%
Calibration mic
6
7
8
Press t'/4, to select [OK].
To cancel, select [Cancell.
Press @.
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
• Befk)rc [Auto Calibration], make sure that the
surround amplifier turns on and you install the
surround amplifier in the appropriate location. If'
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
Confirm the conclusions of [Auto
Calibration].
The speakers connected to the unit fire listed
as [Yesl on the TV screen.
• If measurement fails, R>llowthe message then
retry [Auto Calibration].
• The measurement for [Subwoofcr] is always
[Yes] and [Speaker Settings] returns to the
default setting when you perform [Auto
Calibration].
48.s
To Next Page
Loading...
