Sony BDV-E980 - Network Settings

[Auto]: The system can receive the digital audio
signal of the TV automatically via an HDMI
cable.
[Otfl: Off
m
•This function is available only when [Control for
HDMI] is set to IOn].
• [Quick Start Mode]
[On]: Shortens the startup time from standby
mode. You can operate the system quickly after
tunfing it on.
[Off]: The default setting.
• [Auto Standby]
[Onl: Turns on the [Auto Standbyl function.
When you do not operate the system for about
30 minutes, the system enters standby mode
automatically.
[Off]: Turns offthe function.
• [Auto Display]
_: Automatically displays iufonnatiou ou the
screen when changing the viewing titles, picture
modes, audio signals, etc.
[Off]: Displays int\)rmation only whcn you
press DISPLAY.
• [Screen Saver]
[On]: Turns on the screen saver function.
[Otfl: Oft-
• [Software Update Notification]
[Onl: Sets the system to inform you of newer
software version information (page 57).
[Otfl: Oft-
• [Gracenote Settings]
[Autol: Automatically downloads disc
information when you stop playback of the disc.
To download, the system must be connected to
the network.
[Manual]: Downloads disc information when
[Video Searchl or [Music Searchl is selected.
• [System Information]
You can display the system's software version
information and the MAC address.
[NetworkSettings]
You can make detailed settings for Internet and
network.
• [Internet Settings]
Connect the system to the network beforehand.
For details, see "Step 3: Connecting to the
Network" (page 27).
• [Network Connection Diagnostics]
You can run the network diagnostic to check if
the network connection hits been made properly.
• [Connection Server Settings]
Sets whether or not to display the connected
DLNA server.
• [Renderer Options]
[Auto Access Pennissionl: Sets whether or not
to allow automatic access flom newly detected
DLNA controller.
[Smart Selectl: Allows a Sony DLNA controller
to find the system its the target component to
operate by using the infrared ray. You can set
this tlmction to on or off.
[Renderer Name]: Displays the system's name
its it is listed on other DLNA devices on the
network.
• [Renderer Access Control]
Sets whether or not to accept commands from
DLNA controllers.
• [Party Auto Start]
[On]: Starts a PARTY or joins an existing
PARTY at the request of a networked device
compatible with the PARTY STREAMING
function.
[Otfl: Off.
• [Media Remote Device Registration]
Registers your "Media remote" device.
• [Registered Media Remote Devices]
Displays a list of your registered "Media
reli-lote" devices.
62us