Sony BDV-E980 - Page 51

Deactivating the Buttons
on the Unit
(Child Lock)
You cau deactivate the buttous ou the uuit
(except for I/Q)) for preveutiug misoperatiou,
such as child mischief (child lock function).
Press • on the unit for more than 5
seconds.
"LOCKED" appears in the fi'ont panel display.
The child lock function is activated and the
buttons on the unit are locked. (You can operate
the system by using the remote.)
To cancel, press • for more than 5 seconds so
that "UNLOCK" appears in the fiont panel
display.
• When you operate the buttons on the unit while the
child lock function is on, "LOCKED" flashes in the
front panel display.
ControllingYourTVwith
theSuppliedRemote
By adjustiug the remote sigual, you cau coutrol
your TV with the supplied remote.
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
Code numbers of controllable
TVs
If more than one code number is listed, try
entering them one at a time until you lind the
code that works with your TV.
Manufacturer Code number
SONY 01 (default)
LG 02
PANASONIC 05
SAMSUNG 02, 06
SHARP 03
TOSHIBA 04
VIZIO 07
Changingthe Brightness
of the Front Panel
Display
Press DIMMER.
Each time you press DIMMER, the brightuess of
the fi'out pauel display is chauged.
SavingPower in Standby
Mode
Check that the following settings are both made:
- [Control for HDMI1 in [HDMI Settingsl is set
to [Off] (page 61).
- [Quick Start Model is set to [Off] (page 62).
o
=-,
O
"O
¢D
o
:3
Press and hold TV I/Q) while entering your
TV's manufacturer's code (see the table)
using the number buttons. Then release TV
t/Q).
If the setting is unsuccessful, the currently
registered code is not changed. Re-enter the
code number.
51us