Sound
Symptom Problems and solutions
There is no sound. • The speaker cord is not connected securely.
• Check the speaker settings (page 49).
The Super Audio CD sound of a • HDMI (IN 1) and HDMI (IN 2) does not accept an audio format that contains
component that is connected to copy protection. Connect the analog audio output of the component to the
the HDMI (IN 1) or HDMI (IN AUDIO (AUDIO IN L/R) jacks of the unit.
2) jack is not output.
There is no sound from the TV
via the HDMI (OUT)jack when
using the Audio Return Channel
function.
• Set [Control for HDMI] in [HDMI Settings] of [System Settings] to [On]
(page 61 ). Also, set [Audio Return Channel] ill [HDMI Settings] of [System
Settings] to [Auto] (page 61 ).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
The system does not output • Set [Audio Return Channel] in [HDMI Settings] of [System Settings] to [Off]
sound correctly when connected (page 61 ).
to a set-top box.
Severe hum or noise is heard. • Move your TV away l¥om the audio components.
• Clean the disc.
The sound loses stere() effect • Select stereo sound by pressing AUDIO (page 43).
when you play a CD.
The sound comes from the center • Depending on the disc, the sound may come from the center speaker only.
speaker only.
No sound or only a very low- • Check the speaker connections and settings (pages 20, 49).
level sound is heard from the • Check the surround setting (page 31 ).
surround speakers. • Depending on Ihe source, Ihe elYect of tile surround speakers may be less
noticeable.
• A 2 channel source is being played.
Distortion occurs in the sound of • Reduce the input level for the connected component by setting [Attenuate -
a connected component. AUDIO] (page 59).
Tuner
Symptom Problems and solutions
Radio stations cannot be tuned • Check that the antenna (aerial) is connected securely. Adjust the antenna
in. (aerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning ill with automatic
tuning). Use manual tuning.
Playback
Symptom Problems and solutions
Tile disc does not phty. •The region code on the BD/DVD does not match tile system.
•Moisturc has condensed inside the unit and may cause damage to the lenses.
Remove the disc and leave the unit turned on for about half an hour.
• The system cannot play a recorded disc that is not correctly finalized (page 71 ).
File names are not displayed • The system can only display ISO 8859-1-compliant character formats. Other
correctly, character formats may be displayed diffcrently.
• Depending on the writing software used, the input characters may be displayed
differently.
68u_
To Next Page
Loading...
