Dubbing/Editing
Dubbing/Editing
73
To end Digital program editing
Press MENU.
To save a program without using it to
record
Press MENU in step 11.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 4 in “Recording the
selected scenes as programs” (p. 71).
2 Turn the SEL/PUSH EXEC dial to select
[UNDO] or [ERASE ALL], then press
the dial.
When you select [UNDO]
You can erase the last set program.
When you select [ERASE ALL]
You can erase all the programs.
3 Turn the SEL/PUSH EXEC dial to select
[EXECUTE], then press the dial.
The programs are deleted. To cancel this
operation, select [RETURN], and then
press the dial.
b Notes
• You cannot set starting point or ending point on a
blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 9 on
p. 70, and set the [IR SETUP] code.
To Next Page
Loading...
