Sony DPS-V55 - Additional Information: Precautions; Safety, Placement, and Cleaning Guidelines; Specifications; Technical Data and Characteristics

7
q
Additional Information
Precautions
On safety
* Should any liquid or solid object fall into the unit, unplug the
unit and have the unit checked by qualifiéd personnel! before
operating it any further.
On power sources
¢ Before operating the unit, be sure that the operating voltage of
your unit is identical with that of your local power supply.
¢ Unplug the unit from the wall outlet if it is not to be used for an
extended period of time. To disconnect the cord, pull it out by
grasping the plug. Never pull the cord itself.
¢ AC power cord must be changed only at the qualified service
shop.
On placement
* Place the unit in a location with adequate ventilation to prevent
heat build-up and prolong the life of its components.
* Do not place the unit near heat sources, or ina place subject to
direct sunlight, excessive dust or mechanical shock.
¢ Do not place anything on top of the cabinet which might block
the ventilation holes and cause malfunctions.
On cleaning the cabinet
¢ Clean the cabinet, panels and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol or
benzine.
On repacking
¢ Do not throw away the carton and the packing material. This
makes an ideal container when transporting the unit. When
shipping the unit, repack it as it was packed at the factory.
If you have any question or problem concerning your unit that is
not covered in this manual, please consult your nearest Sony
dealer.
When requesting repairs, all user program data (#201~400)
will be reverted to the original factory data settings.
Before requesting repairs, be sure to save your important data
using an external MIDIJ-data filer, or by making written notes
of the parameter settings.
20%"
A/D Converter
D/A Converter
20 bit reselution
20 bit resolution
Sampling
Frequency 48 KLIz
Input
reference maximum input
Jack type inputlevel inputlevel impedance circuit type
- PHONE -10 dBu +20 dBu More than unbalanced
or +4 dBu 45 kilohms
Output
reference maximum load
Jack type output level output level impedance circuit type
PHONE ~10 dBu +10 dBu less than 1 unbalanced
or +4 dBu or+20dBu — kilohm
MIDI Input/Output
Frequency Response
Signal-to—Noise
Ratio
Distortion
Effect Algorithms
Memory
Power Source
Power Consumption
Dimensions
Mass
Supplied accessories
Jack: 5 pin DIN (IN x 1, OUT/THRU x 1)
OUT/THRU can be set to cither OUT or THRU
20 Hz ~ 22 KHz (+0, -1 dB)
Greater than 93 dB
Less then 0.005% (1 kHz)
45 (4ch: 9, 2ch: 27, Mono-Pair: 9)
Preset 200 locations (numbers 001~200)
User 200 locations (numbers 201~400)
AC 120 V, 60 Hz
11 W (120 V)
19 x 3'/: x 11°/s inches (482 x 88 x 290 mm)
(WxHxD not including projections)
Approx. 9:6 lbs (3.6 kg)
Operating Instructions (1)
Effect Parameter Guide (1)
Preset Memory Catalog (1)
Design and specitications subject to change without notice.