Sony DSLR-A200 Instruction Manual (DSLR-A200) User Manual

133
Printing images
Printing images
Specifying DPOF
Using the camera, you can specify the images and the number of images to
print before you print images at a shop or with your printer. Follow the
procedure below.
DPOF specifications are left with images after printing. It is recommended
that you unspecify them after printing.
Notes
• You cannot specify DPOF on RAW data files.
• You can specify any number up to 9.
• If you unspecify DPOF, the index print is also canceled.
MENU button t 1 t [DPOF setup] t [All images] or
[Cancel all] t [OK]
Specifying /unspecifying DPOF on selected images
1 MENU button t 1 t [DPOF setup] t [Marked images]
An image is displayed on the single screen.
2 Select the image with b/B on the controller.
3 Select the number of sheets with the / buttons.
• To unspecify DPOF, set the number to “0.”
4 Press the MENU button.
5 Select [OK] with v on the controller, then press the center of
the controller.
Specifying/unspecifying DPOF on all the images

Sony DSLR-A200 Instruction Manual (DSLR-A200) Specifications

General

Model	DSLR-A200
Effective Pixels	10.2 megapixels
Sensor Type	CCD
Sensor Size	23.6 x 15.8 mm
Autofocus Points	9 points
Continuous Shooting Speed	3 fps
LCD Screen Size	2.7 inches
LCD Screen Resolution	230, 400 dots
Viewfinder Coverage	95%
Storage Media	CompactFlash Type I/II, Microdrive
Type	Digital SLR camera
ISO Sensitivity	ISO 100-3200
Shutter Speed	1/4000 to 30 sec
Viewfinder Type	Optical
Lens Mount	Sony A-mount
Battery	NP-FM500H
Weight	532 g (body only)
Dimensions	130.8 x 98.5 x 71.3 mm