46
Camera shake warning indicator
Note
• The (Camera shake warning) indicator is displayed only in the modes that the
shutter speed is automatically set. This indicator is not displayed in M/S/P
S
modes.
This Super SteadyShot function can reduce the effect of camera shake by
the equivalent of approximately 2.5 to 3.5 increments of shutter speed.
Due to potential camera shake, the
(Camera shake warning) indicator flashes
in the viewfinder. In this case, use the
Super SteadyShot function, a tripod, or
the flash.
(Camera shake warning) indicator
Using the Super SteadyShot function
Set the switch to “ON.”
• The (Super SteadyShot scale) indicator
appears. Wait until the scale becomes low,
then start shooting.
switch
(Super SteadyShot scale) indicator
To Next Page
Loading...
