152
Warning messages
If the following messages appear,
follow the instructions.
For “InfoLITHIUM” battery only
• An incompatible battery pack is
being used.
Set date and time?
• Set the date and time. If the
message appears frequently, the
internal backup battery is used
up. Replace the battery (pages
25, 154).
Power insufficient
• You tried to perform [Cleaning
mode] when the battery level is
insufficient. Charge the battery
pack or use the AC Adaptor/
charger (not supplied).
No card
• Insert a memory card.
Unable to use card. Format?
•
The memory card was formatted
on a computer and the file format
was modified, or the memory card
was formatted on another device.
Select [OK], then format the
memory card. You can use the
memory card again, however, all
previous data in the memory card
is erased. It may take a some time
to complete the format.
If the message still appears,
change the memory card.
Card error
• An incompatible memory card is
inserted or the format was failed.
Reinsert the card.
• The inserted memory card
cannot be used in your camera.
• The memory card is damaged.
• The terminal section of the
memory card is dirty.
Processing...
• When Long exposure noise
reduction will be done for the
same amount of time that the
shutter was open. You cannot do
any further shooting during this
reduction.
Unable to display.
• Images recorded with other
cameras or images modified with
a computer may not be able to be
displayed.
No lens attached. Shutter is
locked.
• The lens is not attached properly,
or the lens is not attached. When
attaching the camera to an
astronomical telescope or
something similar, set the
recording mode to M.
To Next Page
Loading...
Need help?
General
