Sony DSLR-A200 Instruction Manual (DSLR-A200) User Manual

22
To remove the memory card
• The memory card may be hot just after it has been used for a long time.
Be careful when you handle it.
• When the access lamp is lit, do not remove the memory card or the
battery pack, or turn off the power. The data may be corrupted.
• Data may be damaged if you place the memory card near strongly-
magnetized material or use the memory card in a static-prone or
electrically noisy environment.
• We recommend backing up important data, such as to a hard disk of a
computer.
• When you carry or store the memory card, put it in the case supplied with
it.
• Do not expose the memory card to water.
• Do not touch the terminal section of the memory card with your hand or a
metal object.
On the CF card/Microdrive
• Be sure to format the CF card/Microdrive using this camera when you use
it for the first time.
• Do not remove the label of a CF card/Microdrive or attach a new label
over the label.
• Do not press on the label strongly.
Notes on use of the Microdrive
A Microdrive is a compact and lightweight hard disk drive that complies with
CompactFlash Type II.
Check that the access lamp is not lit, then
open the memory card cover, push down
the memory card eject lever. After the
card is ejected a little, pull out the
memory card.
Notes on using memory cards
Memory card eject
lever
Access lamp

Sony DSLR-A200 Instruction Manual (DSLR-A200) Specifications

General

Model	DSLR-A200
Effective Pixels	10.2 megapixels
Sensor Type	CCD
Sensor Size	23.6 x 15.8 mm
Autofocus Points	9 points
Continuous Shooting Speed	3 fps
LCD Screen Size	2.7 inches
LCD Screen Resolution	230, 400 dots
Viewfinder Coverage	95%
Storage Media	CompactFlash Type I/II, Microdrive
Type	Digital SLR camera
ISO Sensitivity	ISO 100-3200
Shutter Speed	1/4000 to 30 sec
Viewfinder Type	Optical
Lens Mount	Sony A-mount
Battery	NP-FM500H
Weight	532 g (body only)
Dimensions	130.8 x 98.5 x 71.3 mm