The
aperture
value
and/or
shutter
speed
flash
when
you
press
the
shutter
button
halfway
down.
• Since the subject
is
too bright or too dark, it is beyond the available range
of
the camera. Adjust the setting again.
The
image
is
whitish
(Flare).
Blurring
of
light
appears
on
the
image
(Ghosting).
• The picture was taken under a strong light source, and excessive light has
entered the lens. Attach a lens hood.
The
corners
of
the
picture
are
too
dark.
•
If
any filter or hood is used, take it
off
and try shooting again. Depending on
the thickness
of
the filter and improper attachment
of
the hood, the filter
or
the hood may partially appear in the image. The optical properties
of
some
lenses may cause the periphery
of
the image to appear too dark (insufficient
light).
The
eyes
of
the
subject
come
out
red.
• Activate the red eye reduction function (page 80).
• Get close to the subject, and shoot the subject within the flash range using
the flash (page 80).
Dots
appear
and
remain
on
the
LCD
monitor.
• This
is
not a malfunction. These dots are not recorded (page 8).
• You may reduce the effect
of
these issues using the "Pixel mapping"
function.
eD
Set the LIVE VIEW/OVF switch to
"LIVE
VIEW."
® Attach the lens cap.
@)
MENU
button
--+
'\
3
--+
[Pixel mapping]
--+
[OK]
The
image
is
blurred.
• The picture was taken in a dark location without the flash, resulting in
camera shake. The use
of
the Super SteadyShot function or a tripod is
recommended.
The
flash can be used
in
this situation (page 46).
The
EV
scale
~ ~
is
flashing
on
the
LCD
monitor
or
in
the
viewfinder.
•
The
subject is too bright or too dark for the metering range
of
the camera.
154
To Next Page
Loading...
